Apollo 61" Modern Metal LED Task Floor Lamp

Q : Will the matte black metal finish get scratched by my cat's claws?

A : The matte black metal is fairly resistant, but sharp claws could eventually leave minor scratches; using a protective rug or pad underneath can help minimize contact.

Q : How do i clean the brass‑gold accents without damaging the coating?

A : First disconnect the lamp from power, then wipe the accents with a soft, dry microfiber cloth. If needed, apply a small amount of mild metal polish using the cloth, avoiding abrasive cleaners.

Q : Does the metal shade develop any discoloration or wear after months of use?

A : The white lining inside the shade stays bright, while the outer metal may develop a faint patina over several years, which is normal and does not affect the lamp’s functionality.

Q : Can this floor lamp handle being moved frequently in a busy living room?

A : Yes, its slim profile and 72‑inch cord make it easy to relocate; just lift the lamp by the base rather than pulling the cord to avoid stressing the connection.

Q : Is the flat round base stable enough that it won’t tip over when a pet brushes against it?

A : The base is weighted and flat, providing good stability for normal use, but a very active pet could cause it to wobble; placing a small rug underneath adds extra steadiness.

Q : Where is the best spot to place this lamp for reading in a bedroom without blocking foot traffic?

A : Position it beside a reading chair or at the foot of the bed where the cord can run along the wall, keeping at least a foot of clearance so foot traffic isn’t obstructed.

Q : Is the included 9w led bulb safe for households with pets that might knock the lamp over?

A : The 9W LED runs cool and is securely threaded, so even if the lamp tips, the bulb is unlikely to break, though it’s still best to keep pets away from the base.

Q : Can i vacuum the base and shade area to remove dust without harming the finish?

A : Yes, use a brush attachment on your vacuum to gently clean the base and shade; avoid direct contact with the metal finish to prevent scratches.